# Quick Answer: How Many Miles Per Gallon Does A Train Get?

## Are trains more fuel efficient than trucks?

U.S.

freight railroads, on average, move one ton of freight more than 470 miles per gallon of fuel.

On average, railroads are three to four times more fuel efficient than trucks.

That means moving freight by rail instead of truck lowers greenhouse gas emissions by up to 75%, on average..

## How far can a train go before refueling?

With the introduction of tenders (a special car containing water and fuel), trains could run 100–150 miles (160–240 km) without a refill.

## How long can a train legally be?

So how long is a train? Freight and passenger. A freight train length is anywhere between 140 feet and 10,000 feet or 1.9 mile. However there were instances where a freight train has reached over 18,000 feet or 3.4 miles, pulling 295 cars.

## Is it cheaper to ship by rail or truck?

For shippers moving large loads over long distances, a combination of truck and rail is cheaper than using trucks exclusively. Not only can more containers be shipped via rail, but trains are more fuel-efficient, making intermodal cheaper for long hauls.

## Do train drivers sleep?

The engineers and conductors get off the train, go to a hotel, rest until the next train comes and run it back to their origin point. … They do sleep on the train either in their own sleeping car, in the case of the sleeper attendants, or in the dorm car, in the case of the diner/snack crew.

## How many miles per gallon does a locomotive get?

The efficiency of this freight haul would be calculated as: (3000 tons x 500 miles) / (3,049 gallons) = 492 ton-miles per gallon. This efficiency might be stated as “a train can move a ton of freight 492 miles on a gallon of fuel.”

## How much fuel does a train use per hour?

As the table in Figure 5 demonstrates, fuel consumption for conventional locomotives can vary from a low of around 3 gallon per hour (gph) while idling, up to a high range of 188 gph while at maximum notch. The most common switch engines for use in intermodal yards would be similar to the GP 9 or GP 38 locomotives.

## Do locomotives have toilets?

Yes, all over the road locomotives, and local use locomotives are equipped with toilets in small rooms in the front hood area of the locomotive. … Some have an air pressure assisted flushing system using fresh water similar to an airline toilet.

## Why train engines are not turned off?

Another reason for not turning off diesel train engines, lies in the engine itself. … It is also interesting to know that while diesel locomotives are idling, fuel consumption is more than when the train is moving. This is because, while idling, the batteries are being charged, and the air compression is in operation.

## How big is a train fuel tank?

The fuel tank is normally under the loco frame and will have a capacity of say 1,000 imperial gallons (UK Class 59, 3,000 hp) or 5,000 US gallons in a General Electric AC4400CW 4,400 hp locomotive.

## Why did they get rid of cabooses?

Today, thanks to computer technology and economic necessity, cabooses no longer follow America’s trains. The major railroads have discontinued their use, except on some short-run freight and maintenance trains. … Railroad companies say the device accomplishes everything the caboose did-but cheaper and better.

## Where does the poop go on a train?

The traditional method of disposing human waste from trains is to deposit the waste onto the tracks or, more often, onto nearby ground using what is known as a hopper toilet. This ranges from a hole in the floor to a full-flush system (possibly with sterilization).